Strobelight - LightBoost Utility for AMD/ATI and NVIDIA

[kevindd992002]

(12-14-2013 01:53 AM)ToastyX Wrote:  

(12-12-2013 10:02 AM)kevindd992002 Wrote:  Oh ok. So with the swapped version installed, how do you enable stereoscopic 3D?

Enable it in the NVIDIA control panel the same way you normally would.

(12-12-2013 10:02 AM)kevindd992002 Wrote:  Do you need to be at LB off when enabling 3D in the NVIDIA CP?

It doesn't matter.

(12-12-2013 10:02 AM)kevindd992002 Wrote:  Also, everytime I uninstall and reinstall an NVIDIA driver do I need to uninstall and reinstall your software as well?

You don't need to uninstall the program, but you might need to reinstall the refresh rates if reinstalling the driver created a new monitor entry. Usually it's not necessary if you're just upgrading the driver.

Ok. With the swapped version, what frequency does 3D mode use? 121Hz? Because the 121Hz is strobed version installed by the Beta 3 program?

Also, when I tried installing Beta 3 (after uninstalling Beta 2) I had the same exact problem as this guy here: https://www.monitortests.com/forum/Threa...52#pid1552 after I rebooted the computer. Any ideas on this?