01-13-2016, 04:57 AM
As stated I have a NEC MultiSync FE2111SB that is connected to my R9 390 via VGA to HDMI.
I'm having issues trying to get it to 1600x1200 85Hz which it natively supports in the manual.
However, I am unable to get it to that while using CRU.
I patched my drivers using the tool for ATI cards.
When I set the CRU for that, while increasing the refresh rate it doesn't show up and when it does the image looks like I rolled the screen back on both sides.
I was able to use 1280x1024 at 90HZ however, I am wishing to use the native resolution.
I've tried HDMI to VGA and DP 1.1 to VGA.
I've taken out the 12th pin on my VGA cable, and I'm also getting a DP 1.2 and new VGA cable tomorrow to test out.
Shouldn't I be able to do 1600x1200 at 85HZ anyways? It should be under the spec of HDMI pixel clock.
Anyone have any ideas..
thanks
I'm having issues trying to get it to 1600x1200 85Hz which it natively supports in the manual.
However, I am unable to get it to that while using CRU.
I patched my drivers using the tool for ATI cards.
When I set the CRU for that, while increasing the refresh rate it doesn't show up and when it does the image looks like I rolled the screen back on both sides.
I was able to use 1280x1024 at 90HZ however, I am wishing to use the native resolution.
I've tried HDMI to VGA and DP 1.1 to VGA.
I've taken out the 12th pin on my VGA cable, and I'm also getting a DP 1.2 and new VGA cable tomorrow to test out.
Shouldn't I be able to do 1600x1200 at 85HZ anyways? It should be under the spec of HDMI pixel clock.
Anyone have any ideas..
thanks