Custom Resolution Utility (CRU)

[ToastyX]

(12-30-2013 10:19 AM)sickgamesentertainment Wrote:  this shit is unreal, it just will not work, not even with one projector.
i really thought that these monitor inf changes would help but nope, not 1.3 not 1.4. i dont know whats wrong but i was gaming one projector for 3 month, how is it possible that now it wont work with even one?

Is there any way i could have deleted the internal edid of the projectors somehow? with the other software?

No, you didn't delete the EDID. If you did, the text files you gave me wouldn't have given the information I needed. CRU only creates software EDID overrides. If you run reset-all.exe and reboot, that will remove all the custom EDID overrides and reset everything back to the original configuration. Make sure you do that before sending the EDID to AMD support; otherwise, they will see the EDID override instead of the original EDID.

(12-30-2013 10:19 AM)sickgamesentertainment Wrote:  Is there anyway to switch the resolution to HDtv? Cause as said, i do remember that the projectors switched resolution when engaging a 3D game and natively displayed an infobox where the resolution was stated, showing "720p / 120hz"! Now it only shows 1280x720 / 120hz.
So i figure its gotta be some kind of Hdtv mode resolution that is required to accept 3D signal... if that makes any sense to you?

I thought this issue was fixed. 720p is 1280x720, and I used the standard HDTV timing parameters, so if that's not working, then I don't know what it's looking for.

I have one more idea. Maybe 3D needs to be defined as 1280x720 @ 60 Hz instead of 120 Hz. First, run reset-all.exe and reboot. Then check if 3D works with a single projector. If it does, use CRU to import this file for the single projector: http://www.toastyx.net/720p120-hdmi-3d-720p60.dat

Then reboot and check if 3D still works with one projector. If it does, then connect all three projectors and use CRU to import that file for all three projectors. Then reboot and check if 3D works with and without Eyefinity.

If 3D doesn't work with a single projector after resetting everything, then something weird is going on. 3D needs to be working with a single projector before trying anything else.

If 3D works after resetting everything but stops working after you import the file with CRU, then I'm missing something in the override. I've been trying to figure out what needs to be added for 3D support to work properly.