Custom Resolution Utility (CRU)

[mikey32230]

(08-10-2014 12:40 PM)lureb74 Wrote:  Hi

is there an advanced guide somewhere available?

Because when I try:

- higher hz than 60hz at 1920x1080p on my monitor, I have only noisy and unstable screens

- on my projector, I get noisy and unstable screens when trying lower hz than 25hz (my target is to fit 24p) at 1920x1080i (540p interlaced).


I want to try to set different values in manual mode, so I wonder if there's a way to get the knowledge on how to set manual values WITHOUT LITTERALLY TOAST MY MONITOR AND PROJECTOR!

Cheers, Lorenzo

Your monitors video output will become unstable when you force it to a higher fps or higher resolution than your monitor can support.

You can manually go through and force resolutions, it shouldn't cause any real damage if you aren't leaving your monitor at unsupported resolutions/fps.
I would look up your monitors native resolutions, and stay within that range, there is no reason to force it to something it doesn't support or can't display.