Custom Resolution Utility (CRU)

[ToastyX]

(08-02-2015 11:05 PM)chaython Wrote:  Hi, thanks for this. But when I set the blink/total etc at the bottom it doesn't seem to remember that part

I'm not sure what you mean. Are the values not being saved? If you mean the radio buttons, those are just there to indicate only one of the values are needed to calculate the other two. It's not a setting that gets saved. The values should be saved.

(08-02-2015 11:05 PM)chaython Wrote:  CVT Reduced Blank works for 1920x1080/70 in nvidia control panel or
1920 1080 / 72
24 3
16 5
1980 1092
- -
Works in Nvidia control panel, but if set in CRU i do get picture but randomly receive input not supported for 4 seconds at a time, audio also skips.

HDMI audio requires a large enough blanking period to transmit the data, so I'm not sure why the custom resolution is working with the NVIDIA control panel. I would use the "LCD native" timing option if the TV can handle that. Keep in mind that HDMI will act like single-link DVI if HDMI support is not defined in the custom extension block, so the TV might handle that differently. HDMI also supports both RGB and YCbCr, but custom resolutions usually use RGB.

(08-02-2015 11:05 PM)chaython Wrote:  I was also wondering, if there was a way to add two audio profiles to the panel, like nvidia notices when it's pass through the stereo or being amped, so I can set a tv audio format and a receiver audio format, [if it is mixed to the same profile I have to reconfigure the audio channels to 2 for the tv or 5.1 for the receiver].

I don't know a way to do that without switching EDIDs. Shouldn't the receiver have a way to do that?

(08-02-2015 11:05 PM)chaython Wrote:  Also how do I add RGB FUll to the EDID as I only see ycbcr

RGB is automatically supported, so it's not defined in the EDID. Use the NVIDIA control panel to set the color format.