Custom Resolution Utility (CRU)

[falkentyne]

(10-18-2015 06:49 AM)kapre420 Wrote:  Custom Resolution Utility,

i found your post here: http://www.overclock.net/t/1364322/overr...as-monitor


because i'm having a problem,i have a new graphics card and my monitor was detecting as generic non pnp monitor,i dont see "benq" as before, and some games was out of range, ( i use dvi to vga for my new card, because my benQ doesnt have DVI) when i put back my old graphics card and put it on vga (without to adapter) it works again it shows "BENQ"

i found out that this is because my pc gives more than 1366x768(so i need to manually edit ini files for some games) and it gives me a lot of display resolution up to 2000x1444 something like that.

so i used your program and now works perfect!! even it still says "generic non PNP" thank you for that.

BUT with your program i saw my BENQ is there! and not active, my generic non PNP is on active, can i use your program to activate my BENQ?

The monitors shown in the menus are the ones currently in the registry. You can't "activate" them like that. The profile is matched for the Benq's ID, and that profile becomes active if you use the direct VGA connection. You're using a convertor so it's going to show up as a new ID, the generic non PNP monitor.

If you had custom resolutions on the Benq profile, you can just create them again. There are "copy" and "paste" commands for the timings. You can just select the Benq, select the timing you want, copy it, create the new timing then hit "paste".

I'm not sure if you can "copy" an entire drop-down profile (To the right where it says edit, paste, delete) at once and then paste it, never tried that. You can try it.