Custom Resolution Utility (CRU)

[Fidelity]

Quote:Increasing the HT has NO benefit whatsoever except putting extra pressure on the scaler. I'm not sure if it will affect certain Vertical totals causing frameskipping or not; if you want I can test that for you. Usually if a certain vertical total causes frameskipping (you can see it EASILY with blur reduction on, in Test UFO->Alien invasion....if you see the image "jump" repeatedly or every several seconds its frameskipping), then try another VT in the range of 1497-1502.

I'm not sure if HT affects that or not. However raising the HT does raise the pixel clock so its not certain what's causing what. NO effect on blur reduction.
Usually there's no 'danger' as far as I know....if it has artifacts then its too high. But usually you should keep the HT at default, and lower it if you want a lower pixel clock.

The only thing that makes the "overdrive" better is by turning on blur reduction first and then setting "AMA" to high AFTER enabling blur reduction. On XL2411Z and XL2420Z (and MAYBE XL2430T, u can test for urself ok?), it lowers the overdrive inverse ghosting by about 10%. On XL2720Z, it lowers it by a drastic 50% (much better), but you have to drop the contrast lower to avoid too much normal ghosting.

*edit* ok changing HT does NOT affect frameskipping is a certain VT frameskips (e.g. VT 1502 at 85hz refresh rate, VT 1501 is perfect on XL2720Z).

I did that test and didn't notice any frameskipping, it's all smooth. I don't really know how to explain this, at VT 1502 and with blur reduction ON, the image looks so clear that you can actually see the individual pixels and the lines they are in, i play CS:GO and it's easy to notice when you look at a smoke grenade or looking at a piece of skin in movies, i think it's related to the pixel clock, because when it goes down it seems to disappear, but the brightness also goes down so i'm not really sure. *thinking about it, it looks like when you go near the tv and see all the pixels crammed in there* I sit at 3 to 4 inches from the screen and it's clearly visible when watching movies or playing CS. More ↑↑↑ HT, Less ↓↓↓ effect. My settings on the monitor:

Blur reduction(ON) - Strobe Duty: 15 (Max is 25/ 0~25)
Strobe Phase: 0 (I can reach 49 before the monitor blacks out)
Black eQualizer: 0
Color Vibrance: 9
Low Blue Light: 0
Instant Mode: On
Auto game mode: Off
-----------------------------
Picture Mode: Standard
Brightness: 100
Contrast: 52
Sharpness: 5
Gamma: 5
Color temp: R:98 / G:100 / B:99
AMA: High

Like i said, using 2080 i notice it very easily and the more i go up in the HT the less i can see. If you know anything about it, let me know! Thanks for all the help!