Custom Resolution Utility (CRU)

[Nazar]

(07-25-2013 07:46 PM)ToastyX Wrote:  I will work on adding support for non-PnP monitors. It has to be handled a little differently, but it seems doable.

Since after using that created by MonInfo .INF driver I was able to make further adjustments to the resolutions via CRU, I've also tried a few more things (because CRU's interface is more user-friendly than the one of Phoenix, and it allows some things which Phoenix doesn't). So, after I made some changes I thought about saving a new .INF file directly from CRU, so I could use it on my others computers to have a ready one-time install solution for a specific monitor. But it appears that the .INF file created by CRU is not working the same way as the one created by MonInfo. I wasn't able to add support for all those custom created resolutions on the other system by simply installing the .INF driver created by CRU. However, when I opened that file by MonInfo and then used the MonInfo option to create an .INF file, then this file started to work and provide support for all custom resolutions (after being installed as a monitor driver)... Hope this helps you to improve the CRU functionality. And thanks again for all your work and support!