Custom Resolution Utility (CRU)

[Signex]

(10-01-2017 11:38 AM)ToastyX Wrote:  

(10-01-2017 07:35 AM)Signex Wrote:  I have a LG 29UM79G-B ultrawide with freesync, 2560x1080/75hz.

I've used the NVIDIA patcher cause i'm using a 780 Ti Matrix.

I have 3440x1440 working, i get an image in-game but still i get the out of range on the screen.
But it actually isn't, cause i can see the game running at the resolution but how do i get rid of this message?

I can't use NVIDIA's DSR cause the resolutions are never shown in-game, wich pisses me off.
CRU is the only solution for downsampling for me.

CRU is not a downsampling tool. CRU is for defining monitor resolutions, not scaled resolutions. The monitor must support the resolution. You can't get rid of the "out of range" message. That's the monitor telling you it doesn't officially support the resolution. Secondly, I don't understand why you're using the patch. It shouldn't be needed with HDMI or DisplayPort. Also, have you checked if that monitor can actually do 75 Hz with an NVIDIA card? Many 75 Hz FreeSync monitors skip frames at refresh rates greater than 60 Hz without an AMD card. Use this test with a camera: http://www.testufo.com/#test=frameskipping

Yes it can do 75hz with a NVIDIA card, been running it at 2560x1080/75hz for months without obvious frame skipping.

It used to work downsampling with CRU, i guess not for this monitor.

If i use NVIDIA for DSR or custom resolution, not a single game lets me choose it.