Strobelight - LightBoost Utility for AMD/ATI and NVIDIA

[BxBender]

(11-15-2013 09:57 PM)ToastyX Wrote:  

(11-14-2013 08:04 PM)BxBender Wrote:  In the tool i can change 10-100% brightness, but i cannot use the key for strobelight off. I deinstalled and installed 3 times. Same issue.
Only going into monitor settings and choosing 60hz deaktivate strobelight. I do not see 101 and 121 there?! 100 and 120 give me strobelight mode on again and i can activate it with the tool too.

Any idea how i can get the tool switching strobelight on/off in booth directions???

Strobing off isn't working because the refresh rates aren't available for some reason. 121 Hz and 101 Hz are supposed to be listed in the Windows monitor settings if you installed them. I'm not aware of any issues with installing refresh rates on AMD cards, so I don't know why that's happening to you.

Check the device manager under display adapters and make sure you don't have any mirror drivers or anything else other than your video card.

Make sure "reduce DVI frequency on high-resolution displays" is NOT enabled in the Catalyst Control Center.

What happens if you only install 120 Hz and 111 Hz? Do they both get listed in the Windows monitor settings or are there other refresh rates listed?

Ompf. I tested it now with beta 2. Same problems. AMD CCC shows me 60,75,100,120hz. Strobelight mode is in 100 and 120 always on. 60 is off. 75 does not work in full hd mode.