Strobelight - LightBoost Utility for AMD/ATI and NVIDIA

[bennyc500911]

hi,

i have a problem after using the setup, putting the strobelight.exe into startup and rebooting, i get a red error message when entering 3d Mode:

Quote:Warning attempt to run Stereoscopic 3d in non-stereo display mode, please change to an acceptable mode.
see decumentation for acceptable Stereoscopic 3d modes.

3d is working perfectly fine but the error message (only on the left eye) is still there.
when i reset the displays the message is gone.
i used 120hz strobed and 121hz non-strobed modes, both give me the error.
using a XL2411T monitor and a gtx 780. geforce driver 331.82

---

(12-28-2013 01:32 AM)bennyc500911 Wrote:  hi,

i have a problem after using the setup, putting the strobelight.exe into startup and rebooting, i get a red error message when entering 3d Mode:

Quote:Warning attempt to run Stereoscopic 3d in non-stereo display mode, please change to an acceptable mode.
see decumentation for acceptable Stereoscopic 3d modes.

3d is working perfectly fine but the error message (only on the left eye) is still there.
when i reset the displays the message is gone.
i used 120hz strobed and 121hz non-strobed modes, both give me the error.
using a XL2411T monitor and a gtx 780. geforce driver 331.82

nevermind found the swapped version myself ._.
i should read the whole post before asking questions