Strobelight - LightBoost Utility for AMD/ATI and NVIDIA

[falkentyne]

(11-28-2014 10:41 PM)khoax Wrote:  I'd like to start off by saying thanks for making this program! Now the issue...

I have two monitors, a S200HL at 60hz and my VG248QE at 120hz lightboost. The program installed correctly and works fine but if the 60hz monitor is on then the ufotest is blurry. If I turn the 60hz monitor off the UFO test is mostly smooth. Is there any workaround to turning my 60hz monitor off or do I have to live with this because of mismatched monitors?

AMD 7770
Intel HD 4770k OC'd to 4.0

Also, as a side note, i had an older version of AMD Catalyst (before 14.9) and the strobelight.exe wouldn't run and wouldn't give an error. Updating to the beta driver fixed it instantly. Just giving a heads up for other people with the same problem.

Is the refresh rate of the VG248Qe switching to 60hz? Does it say 3d mode when testufo is blurry? (the OSD should have most options disabled). You should be able to set the VG248 and the 60hz monitor to different refresh rates, but I don't think that's possible if you're running a surround setup. Ive had my Benq 2720Z hooked up through DVI and VG248 hooked up through HDMI in clone mode, and I was able to set display 1 and 2 separately. If you're running it in eyeinfinity though, I'm pretty sure that all screens must be at the same refresh rate and that's unavoidable (how would a game run at 120 FPS on one screen on the left side while the right side runs at 60 fps?)