Strobelight - LightBoost Utility for AMD/ATI and NVIDIA
|
09-16-2015, 02:31 PM
Post: #790
|
|||
|
|||
RE: Strobelight - LightBoost Utility for AMD/ATI and NVIDIA
(09-14-2015 05:06 PM)kevindd992002 Wrote: Well, that last refresh rate set was 121 Hz (I use the swapped version) before a restart on the computer. Do you have any ideas why it happens randomly? And how will Windows start at 3D mode if not for strobelight.exe? It's just that scenario 2 adds to boot time significantly.After Strobelight unlocks 3D mode, the strobing is controlled by the installed refresh rates. Strobelight doesn't control what refresh rate the logon screen uses. I would expect it to use either the last set refresh rate or the first detailed resolution, which should be strobed. If that's not happening, then I don't know. Try running the reset-all.exe that comes with CRU, and then run restart.exe. That will reset the Windows screen resolution settings. Then reinstall the refresh rates and reboot. If that doesn't help, then there isn't much I can do about this. I don't even consider this a problem. Strobelight was meant to run after logging in. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)