Strobelight - LightBoost Utility for AMD/ATI and NVIDIA

[Calypto]

Hey, I just wanted to confirm that with the 418.91 driver, I was able to turn on stereoscopic 3D and then enable Lightboost on my MG248Q with Strobelight. Unfortunately I didn't like the flicker and the input lag, but it was interesting to try out for the first time.

Thanks for the utility.

I left out other important steps in the original post:

1. Adaptive sync actually needs to be on in the OSD
2. I'm not sure if this matters, but I'm using the 120Hz strobed refresh rate vs. 121 strobed
   

After doing this, I can now consistently activate Lightboost.