Strobelight - LightBoost Utility for AMD/ATI and NVIDIA
|
12-24-2019, 04:27 AM
(Last edited: 04-22-2020, 02:44 PM by TeddyTries)
Post: #977
|
|||
|
|||
ASUS MG248Q
So, to everyone with this monitor it is actually still posible to enable strobelight application by rolling back to the last version of Nvidia Geforce Driver that supported 3D stereoscopic settings this being version 418.91 then following step #3 from the Blur buster Lightboost: Howto. after doing this you should be able to go and do step #1 from the Lightboost: Howto and be able to run the Strobelight setup and also the strobelight application. Not sure if this would make a difference in the future. But, I manage to update back to the latest Nvidia Geforce Driver 441.66 and still be able to run the Strobelight application without any problems. Not sure if the monitor loses power it will make me do all the steps all over again or just work again. Haven't tried it and don't want to atm.
Make sure to disable Freesync in the monitor settings and in the controle panel as well. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 7 Guest(s)