Custom Resolution Utility (CRU)

[ToastyX]

(11-01-2020 12:23 AM)botounacruzeta Wrote:  Note: I installed INF file using Windows only, and updated Monitor driver using Device Manager. I only opened CRU to show you how it displays things after inf is loaded.

This is frustrating because I can't pinpoint any particular change that is triggering the problem.

Are you sure about this:

(10-31-2020 08:13 PM)botounacruzeta Wrote:  I could also open NVCPL after doing these simple steps:

-run reset-all.exe;
-restart GPU;
-In CRU, enable both "Include if slot available" options under "Range limits" and under "Serial number";
-import the CRU-exported settings (default ones) using CRU;
-restart GPU;

Importing the file should disable both the range limits and serial number since they aren't included in the file, so it should be exactly the same as just importing the file. You also said choosing "Import complete EDID" worked alone, but that shouldn't make any difference because there weren't any changes made to the non-imported parts. You also said enabling the range limits and serial number worked after installing the MonInfo .inf file and importing the CRU-exported settings, but then CRU would just make the same changes that it would without installing the .inf file.

What happens if you use Device Manager and right-click and choose "Scan for hardware changes" after restarting the driver?

The only other thing I can think of is try using DDU: https://www.wagnardsoft.com/display-driv...aller-ddu-

Then reinstall the driver, and try the non-DCH drivers.