|
Custom Resolution Utility (CRU)
|
|
01-14-2014, 09:58 PM
Post: #573
|
|||
|
|||
RE: Custom Resolution Utility (CRU)
(01-14-2014 02:01 AM)Leopard2lx Wrote: So I have a Panasonic Plasma 3D P42ST30 and after running CRU and setting the refresh rate to 1920x1080 @ 120Hz under "Deatailed Resolutions", uncheck "Include Extension Block" and Reboot, but I get to Windows I have NO SIGNAL.Does your TV actually support 120 Hz? Is it connected via HDMI? Did you patch the driver to get around the 165 MHz pixel clock limit? You might be able to get around the limit without patching the driver by enabling the extension block and importing this file in CRU: https://www.monitortests.com/hdmi-audio.dat If you did that and it still doesn't work, then the TV might not support 120 Hz input. If you didn't do that, it shouldn't boot with no signal unless you deleted 60 Hz. Did you add 120 Hz as a separate resolution? You can boot into safe mode and run CRU from there, or you can run reset-all.exe to reset everything. |
|||
|
|
« Next Oldest | Next Newest »
|