Custom Resolution Utility (CRU)
|
02-13-2014, 06:43 PM
(Last edited: 02-13-2014, 06:45 PM by jobby)
Post: #696
|
|||
|
|||
RE: Custom Resolution Utility (CRU)
I found out that my monitor goes "out of range" at 74Hz, so I suppose that's its limit. At 73Hz it's fine, though, with no skipped frames.
I tried these two settings: "Manual" (default) on the left and "Automatic - LCD standard" on the right. The manual setting works fine, but with the LCD standard I get artifacts, kinda similar to the "snow" on analog TVs, mostly around edges: I also tried some random in-between values and got in-between amount of artifacts. And the last "Automatic - LCD standard" frequency without artifacts is 68Hz. Since I'm clueless about those CRU settings (porch, sync width...): Besides the evident artifacts, do those settings affect anything visually? Are some better than others in some aspect, should I look for the artifact-less limit? |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 83 Guest(s)