Custom Resolution Utility (CRU)
|
04-07-2014, 10:50 PM
Post: #819
|
|||
|
|||
RE: Custom Resolution Utility (CRU)
(04-06-2014 07:31 AM)rmike1991 Wrote: That helped. THANK YOU! This CRU is not affecting the audio (we are almost there). But now there is a different problem. When I want to turn the TV on/off or when switching HDMI 1-> HDMI 2 etc (my TV has 4 of them) with remote control, both screens (TV and monitor) are refreshing twice and a message pops up:That happens because your TV stops transmitting the EDID when turning it off or switching inputs, so it's like the TV is disconnecting. I guess at some point when the TV disconnects, the driver is assuming you're using an HDMI-DVI cable, but if that's not causing problems, then just check "Don't display this message again" to ignore it. (04-06-2014 07:31 AM)rmike1991 Wrote: And here's what happens when watching the video. When the screens refresh the movie is not full screen any more. There is a black bar on the right side which cuts something like 1/4 of the movie. You know they say that the picture=1000 words. I think the video is even better ;}. So here is another short one.That's an issue with the video player not handling the resolution changes properly when the TV disconnects. Does that happen with the latest version of VLC? Some people with a media center setup use a device like the HDMI Detective to trick the video card into thinking the TV is always connected to avoid problems like this. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 57 Guest(s)