|
Custom Resolution Utility (CRU)
|
|
05-22-2014, 03:49 AM
Post: #894
|
|||
|
|||
RE: Custom Resolution Utility (CRU)
(05-22-2014 03:26 AM)ToastyX Wrote:(05-22-2014 01:40 AM)lawson67 Wrote: Ok i just tried that i created a 110hz resolution along with the 60hz standard resolution with CRU and saved it as an inf from CRU!...on the first re-boot windows could see them both 60hz and 110hz but on the second reboot windows could not see the 110hz again only the 60hz?....so It was back to only seeing 60hz again?....Would it be best to run the reset-all.exe and then install the inf in device manager?....Or use the inf along side the CRU overrides?...which is only working randomly right now...I'm trying to figure out why your .inf file works for you while CRU does not. There should be no difference between using CRU and installing the .inf file. The override is installed in the same place. If you install the .inf file using the Device Manager, the resolutions in the override should show up in CRU. Ill try tomorrow toasty its 4.30am here UK time need sleep!....I am sure its that bloody Epson printer software that has mess things up!....However i have stopped all of that stuff loading at boot up so yeah i am lost....Also dont know why the other driver works i made that with monifo....Thinking about doing a roll back to before i installed that printer and see if windows has drivers for it instead...but i doubt windows has or it will work correctly as it does so much...scanner/ printer/fax / even makes you a cuppa tea i think!...its the Epson WF-3520...to tired to think right now....Thanks for your help so far toasty |
|||
|
|
« Next Oldest | Next Newest »
|