Custom Resolution Utility (CRU)

[ToastyX]

(08-10-2014 12:40 PM)lureb74 Wrote:  Hi

is there an advanced guide somewhere available?

Because when I try:

- higher hz than 60hz at 1920x1080p on my monitor, I have only noisy and unstable screens

- on my projector, I get noisy and unstable screens when trying lower hz than 25hz (my target is to fit 24p) at 1920x1080i (540p interlaced).


I want to try to set different values in manual mode, so I wonder if there's a way to get the knowledge on how to set manual values WITHOUT LITTERALLY TOAST MY MONITOR AND PROJECTOR!

Cheers, Lorenzo

There's no way to know what values your projector will accept and display properly when trying unsupported refresh rates. If the projector supports 24 Hz, then the "LCD standard" timing option should work. If not, you might have to use the 25/50 Hz or 30/60 Hz values. The only difference between them is the horizontal front porch, and you can switch back to the "Manual" option to change the refresh rate without affecting the values. If that still doesn't work, then the projector might not be able to handle 24 Hz.