Custom Resolution Utility (CRU)

[evertec]

(09-13-2014 11:22 AM)ToastyX Wrote:  

(09-11-2014 01:18 PM)evertec Wrote:  I got 1440 enabled using the LCD -reduced setting, however, no matter what I set the refresh rate to in the CRU, Windows only shows 30hz. Any ideas of what to do to enable higher refresh rates?

Try importing one of these files:

(09-07-2012 09:06 PM)ToastyX Wrote:  

• Some monitor/GPU combinations can bypass the 165 MHz HDMI limit without patching the driver by enabling the extension block and importing one of these files:
  • hdmi.dat (HDMI support only)
  • hdmi-audio.dat (HDMI support with basic audio)
  • hdmi-bitstream.dat (HDMI support with bitstreaming for A/V receiver)
    

Thanks for the tip. However, I tried importing the hdmi-audio.dat file and checking the enable extension block, but still Windows won't allow me to set anything other than 30Hz even when 60Hz is set in CRU. If I use a displayport or DVI to HDMI adapter on another output of the video card, my TV immediately won't display at all when restarting the computer after setting the 60Hz in CRU. Any additional tips would be greatly appreciated.