Custom Resolution Utility (CRU)

[ToastyX]

(05-10-2015 09:30 AM)Dave3d Wrote:  Monoprice 30 inch G-Pro Slim 2560 x 1600 monitor that they say will oc to 120hz

It can't overclock. This is shown in the review on the front page: https://www.monitortests.com/monoprice-2...hz-review/

Tom's Hardware also has a review now with the same results: http://www.tomshardware.com/reviews/mono...,4117.html

(05-10-2015 09:30 AM)Dave3d Wrote:  I have gotten 65hz and 70hz to work, but if I go over 70hz (in the Detailed Resolutions), only 60hz and 65hz show (or, if I delete the 65 and 70 hz, only 60hz shows up).

You're not paying attention to pixel clock limits. You need to patch the driver to allow pixel clocks greater than 330 MHz with dual-link DVI when using EDID overrides: https://www.monitortests.com/forum/Threa...ck-Patcher

(05-10-2015 09:30 AM)Dave3d Wrote:  EDIT:
Nevermind.
I was able to do it through the Nvidia control panel, change resolution, create custom res, 100hz, bam.
Reboot, and flip it to 100hz, all good.
Now to check gaming.

The frame skipping at 100 Hz should be very obvious just by moving the mouse cursor.