Custom Resolution Utility (CRU)
|
06-03-2015, 11:42 AM
(Last edited: 06-03-2015, 12:01 PM by JonnyRedHed)
Post: #1429
|
|||
|
|||
RE: Custom Resolution Utility (CRU)
I think I've found something that might need your attention if it can be fixed. In the last few Nvidia drivers there has been the option to choose between 8bit and 10bit (12bpc). My 50 inch LG plasma can do 10bit but as I've installed these recent drivers I only had the 8 bit option (8bpc) after I restore my CRU profile etc and reboot.
I've just stumbled on something new as I installed the latest NVIDIA Driver 353.06 (and 353.12 hotfix driver). Before I got around to reloading my usual CRU profile and hdmi-audio etc. I noticed my NV panle was showing both 8bit and 10 bit (12bpc) options. But after I 'ok'ed and rebooted after CRU it was gone. So I reset-all using your exe and rebooted and sure enough the 12pbc option was back again and could be set. I could then actualy see the 10bit when using the 10bit option via MadVR renderer. Is there a way you could look into this with regards to these new recent NV drivers that allow 10bit output. It says 12bpc in the NV control panel. I've retested this a few times and for me at least when I run my usual CRU set up when installing a new driver, it wipes the option to have 12bpc in the NV control panel. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 115 Guest(s)