|
Custom Resolution Utility (CRU)
|
|
06-08-2013, 04:27 AM
(Last edited: 06-08-2013, 04:27 AM by Albert Kike)
Post: #141
|
|||
|
|||
|
RE: Custom Resolution Utility (CRU)
Ok, so I wasn't going into test mode before rebooting. Now my GPU's are being recognized, but the custom resolution I set is not. This is what I did:
Made sure two crossfire bridges were connected. Ran the patcher for higher pixel clocks/rates, rebooted with test mode. Opened CRU utility and entered in custom resolution of 3840x2160 @ 60Hz, rebooted. Opened up CCC to check if custom resolution was there; nothing. What am I doing wrong? Again, I have an older Samsung T260HD monitor, for whatever that info is worth. |
|||
|
|
« Next Oldest | Next Newest »
|