Custom Resolution Utility (CRU)
|
09-27-2016, 10:27 PM
(Last edited: 09-27-2016, 10:28 PM by falkentyne)
Post: #2305
|
|||
|
|||
RE: Custom Resolution Utility (CRU)
I hope I'm not getting too far off topic here, and if this belongs in the Strobelight section, please move it there, but Lightboost mode exists on the 1440p monitors that support 3d vision 2!
Not only that, you can *ENABLE* Gsync and ULMB mode at the same time by exploiting what appears to either be a driver bug or a firmware bug, where ULMB gets triggered in place of Lightboost, and strobes in sync with Gsync all the way down to 40hz (where it suddenly double strobes)! If I'm understanding this right, Lightboost mode gets "enabled" by a custom resolution, but the monitor says it's in ULMB mode when it's in fact in Lightboost mode, then Gsync enables itself and it starts strobing at variable refresh rates without going out of sync (some games show bugs however). http://forums.blurbusters.com/viewtopic.php?f=4&t=2883 Variable refresh rate and GSYNC is VERY well 100% possible--just being BLOCKED from us by the manufacturers Someone really needs to donate a 1440p Dell Gsync monitor to ToastyX so he can help us What we need to know are if there are custom vertical total values that activate lightboost on 3d vision 2 supported 2560x1440p monitors, or even if the Nvidia driver can be tricked by changing the product ID to ACI27F8 .... |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 106 Guest(s)