Custom Resolution Utility (CRU)
|
07-23-2013, 09:21 PM
Post: #189
|
|||
|
|||
RE: Custom Resolution Utility (CRU)
I'm just updating to say that I've followed the tutorial from SevenForums and was able to create the required .INF file. And it works like a charm!!! I used the registry data for another monitor in Phoenix and changed the Standard Timings to reflect what I wanted to have. Then I created the .INF file and used it as a driver for my Generic non-PnP monitor. And it worked!!! And what is great is that now it also automatically applies the desired refresh rate whenever I switch to any resolution out of those I created with Phoenix.
I have just one more question. My monitor allows up to 160 Hz refresh rates and up to 2560*1536 resolutions. With Phoenix, however, I was able to set the refresh rate even for lower resolutions (like 800*600) to a maximum of 123 Hz. If I try to set the refresh rate higher, it says that the refresh rate must be not more than 123 Hz. Why so? Any way to change that? And thanks again for the directions!!! |
|||
« Next Oldest | Next Newest »
|