Custom Resolution Utility (CRU)

[jillo]

(11-30-2016 10:50 PM)ToastyX Wrote:  

(11-30-2016 04:46 AM)jillo Wrote:  Is there a way to use Nvidia Surround with 3 overclockable monitors (2x QX2710 and 1x Yamakasi Catleap) on a custom refresh rate? When Nvidia Surround is enabled I can only see 60 Hz.

Set up each monitor individually first with Surround disabled, and make sure the refresh rate you want is available on all three monitors. Ideally they should all have the same exact resolutions and timing parameters in CRU. Then set up and enable Surround.

I went and tried that just before. I can see the custom refresh rate (105Hz) in the Surround option, but when I enable Surround it defaults back to 60 Hz and the option disappear altogether.

If I disable Surround the 105Hz option appeared again.