Custom Resolution Utility (CRU)

[ToastyX]

(04-05-2017 09:08 AM)zeroyon04 Wrote:  Is there any way to use CRU to "trick" my computer and monitor into thinking I am using DVI dual-link, although I am using HDMI 1.4a?

My screen keeps flashing a large message box in the center, that says
"Incorrect cable. Please use the dual link DVI cable that came with your monitor."
even if I successfully overclock using HDMI.

No because that happens when the monitor receives a single-link DVI signal greater than 165 MHz pixel clock, and HDMI ports can only transmit single-link signals. If that's happening on the monitor's HDMI port with the HDMI support data block included, then whoever designed the monitor's firmware got lazy and just applied the same logic to HDMI. You shouldn't need the patch with the HDMI support data block included.