Custom Resolution Utility (CRU)

[purecussion]

(09-01-2013 03:00 AM)ToastyX Wrote:  There isn't any change in 1.0.1 that would cause that to happen.

https://www.monitortests.com/old/cru-1.0.zip

and naturally, you're right.

I followed the instructions to the T but I'm still getting horrible glitches.

I have a 7970 and a QNIX monitor. Now, when I built the computer the first time, I had amazing results at 120hz other than the red lines for a while. After I brought it down to 110hz which got rid of the red lines, I began to run into problems where the screen would flicker and eventually black out.

So I began troubleshooting. Reset both CRU and ATI Patch. Reinstalled 13.8beta-> applied current ATI patch-> reboot computer-> Open CRU and copy/paste stock 59hz settings-> tweak 2nd profile refresh rate to 110Hz->bring it to the top-> reboot computer -> BIOS splash good! Windows 7 64 bit Loading logo GOOD! -> the MOMENT it enters the desktop, screen flickers and then blacks out immediately. I have to go to safe boot to reset CRU to get back into desktop normally.

What am I missing? It worked the first time and I followed the Youtube videos, what has changed? I tried it with 13.4 CCC as well. Same results.