Post Reply
 
Thread Rating:
  • 3 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Strobelight - LightBoost Utility for AMD/ATI and NVIDIA
01-04-2014, 06:45 PM
Post: #383
RE: Strobelight - LightBoost Utility for AMD/ATI and NVIDIA
(01-03-2014 04:17 PM)tommy Wrote:  I'm using two monitors (BenQ XL2410T and ASUS VG278HE) , both connected with DVI-D cables.

When I use this utility to enable lightboost my secondary monitor (BenQ) displays the following message:
"incorrect cable. Please use the dual-link DVI cable that came with your monitor"

The BenQ supports 120hz.
The ASUS supports 120hz and lightboost.

What steps should I take to resolve this issue?
Are you using dual-link DVI cables? That message should only appear if the monitor is receiving a single-link DVI signal at higher refresh rates.

What video card do you have? AMD cards normally only have one dual-link DVI port, but then it should run at 60 Hz instead. I've only seen that message if I try to force higher refresh rates over a single-link DVI connection, but that shouldn't be possible unless you used my pixel clock patch. I can't think of any other situation where that message would show up.

If you only installed refresh rates on the ASUS, then it shouldn't affect the BenQ.
Find all posts by this user
Quote this message in a reply
 Post Reply


Messages In This Thread
RE: Strobelight - LightBoost Utility for AMD/ATI and NVIDIA - ToastyX - 01-04-2014 06:45 PM
3D Vision WITHOUT LightBoost??? - weasel - 02-19-2014, 08:07 AM
RE: GeForce 344.11 - jayache80 - 10-06-2014, 02:25 AM
uninstalling failed? - l8nite - 11-04-2014, 06:21 PM

Forum Jump:


User(s) browsing this thread: 4 Guest(s)