Post Reply
Strobelight - LightBoost Utility for AMD/ATI and NVIDIA
01-10-2017, 03:17 PM
Post: #880
RE: Strobelight - LightBoost Utility for AMD/ATI and NVIDIA
(01-07-2017 09:42 PM)Podranok Wrote:  But... can i use both Lightboost and Benq Blur Reduction at the same time? It seems i use them both now as the guide methor 3 says. And if i uncheck "Enable stereoscopic 3D" button Lightboost turnes off. I'm kinda confused.
LightBoost and BenQ's blur reduction are both forms of backlight strobing, so it doesn't make sense to use them both at the same time. Disabling stereoscopic 3D shouldn't disable LightBoost. The point of that guide is to use the wizard to unlock LightBoost in the monitor. Then you can use Strobelight or CRU to enable LightBoost using custom resolutions. That was the point of using CRU in the guide. LightBoost should be active when any of the custom resolutions are active. You can also use Strobelight now that LightBoost is unlocked. Strobelight normally takes care of the unlocking part, but it can't do that for newer monitors.
Find all posts by this user
Quote this message in a reply
 Post Reply


Messages In This Thread
3D Vision WITHOUT LightBoost??? - weasel - 02-19-2014, 08:07 AM
RE: GeForce 344.11 - jayache80 - 10-06-2014, 02:25 AM
uninstalling failed? - l8nite - 11-04-2014, 06:21 PM
RE: Strobelight - LightBoost Utility for AMD/ATI and NVIDIA - ToastyX - 01-10-2017 03:17 PM
ASUS MG248Q - TeddyTries - 12-24-2019, 04:27 AM

Forum Jump:


User(s) browsing this thread: 5 Guest(s)