Post Reply
Strobelight - LightBoost Utility for AMD/ATI and NVIDIA
12-24-2019, 04:27 AM (Last edited: 04-22-2020, 02:44 PM by TeddyTries)
Post: #977
ASUS MG248Q
So, to everyone with this monitor it is actually still posible to enable strobelight application by rolling back to the last version of Nvidia Geforce Driver that supported 3D stereoscopic settings this being version 418.91 then following step #3 from the Blur buster Lightboost: Howto. after doing this you should be able to go and do step #1 from the Lightboost: Howto and be able to run the Strobelight setup and also the strobelight application. Not sure if this would make a difference in the future. But, I manage to update back to the latest Nvidia Geforce Driver 441.66 and still be able to run the Strobelight application without any problems. Not sure if the monitor loses power it will make me do all the steps all over again or just work again. Haven't tried it and don't want to atm.

Make sure to disable Freesync in the monitor settings and in the controle panel as well.


Attached File(s) Thumbnail(s)
           
Find all posts by this user
Quote this message in a reply
 Post Reply


Messages In This Thread
3D Vision WITHOUT LightBoost??? - weasel - 02-19-2014, 08:07 AM
RE: GeForce 344.11 - jayache80 - 10-06-2014, 02:25 AM
uninstalling failed? - l8nite - 11-04-2014, 06:21 PM
ASUS MG248Q - TeddyTries - 12-24-2019 04:27 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)