Custom Resolution Utility (CRU)

[ToastyX]

(01-12-2022 04:04 PM)notJeff Wrote:  Hello, I've been using cru for a while without problems. But today when trying a new resolution for my 2nd monitor and clicking "ok" a pop-up shows and says something like "some settings didn't save" or it was something like that, I forget. Rebooted pc, all 2 monitors are active and fine. So I open CRU and it didn't detect my 2nd monitor only shows my first monitor. The 2nd monitor is active and I can change resolution and stuff. So then I try reset-all.exe but CRU still didn't detect my 2nd monitor.

Any ideas on how to fix this?

There must be something in the registry that CRU couldn't process. Use RegEdit to export HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Enum\DISPLAY to a .reg file and upload it here so I can see if there's anything unusual.