Custom Resolution Utility (CRU)

[eortizo]

(02-14-2013 05:21 AM)ToastyX Wrote:  

(09-07-2012 09:06 PM)ToastyX Wrote:  

• This program adds monitor resolutions, not scaled resolutions. Lower resolutions will be scaled up if GPU scaling is enabled, but higher resolutions won't be scaled down by the GPU. Higher resolutions will only work if the monitor can handle them.
• Single-link DVI and HDMI are limited to 165 MHz pixel clock unless the video driver is patched:
  • AMD/ATI Pixel Clock Patcher
  • NVIDIA Pixel Clock Patcher
    

Single-link DVI and HDMI ports: The driver will ignore any resolutions past 165 MHz pixel clock unless the driver is patched. The patched driver will allow 2560x1440 @ 60 Hz over a single link, but the monitor has to support it.

Dual-link DVI ports: The driver will send a dual-link DVI signal past 165 MHz unless the driver is patched. The patched driver only raises the switchover value to 235 MHz to avoid interfering with dual-link DVI monitors, so 2560x1440 @ 60 Hz will not work properly with single-link DVI monitors.

This program was not intended for downscaling higher resolutions.

I see, then i will have to save and get a better monitor, thanks for replying!