Custom Resolution Utility (CRU)

[Ambro]

Hi Toasty, I wanted to first thank you for all of your hard work with CRU. I've run into a bit of an issue with my monitor when using CRU and now I'm desperately looking for a way of fixing this issue. I was following a guide for enabling GSYNC on both of my BENQ BNQ7F45 monitors and in the process of doing this, I replicated the timing settings for my first monitor over to my second, which is the same monitor, but a more current iteration (more recent Firmware). Anyhow, I made sure to perform an export from CRU thinking that if I ever needed to revert anything I changed, I could readily do that and since I've made these changes, my second monitor is now locked at 120hz. My primary will do 144hz, without an issue. I've tried using the reset feature of CRU and rebooting, even downloaded and ran DDU to blow out the drivers. Last thing I just tried was running regedit as the system user, and blowing out the two registry keys associated with my monitor in Computer\HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Enum\DISPLAY

I rebooted, checked the refresh and it's still locked at 120hz. I'm baffled by this, and have no idea how to fix this. When I check the timings in CRU for my second monitor, it's like the settings I applied are somehow stuck now, and won't revert back to whatever the defaults were. I'm not sure what to do, and am hoping you might have some suggestions.

Thank you for any help you can offer.