|
Custom Resolution Utility (CRU)
|
|
11-02-2013, 11:13 PM
Post: #407
|
|||
|
|||
RE: Custom Resolution Utility (CRU)
(11-02-2013 09:03 PM)neptune Wrote: New here... and I must admit it's very interesting stuff. I've managed to run my old P2370H at 75hz (instead of stock 60hz), but no luck with OC above (although I've managed to run it at 85Hz with "LCD Reduced" setting, but it resets after few minutes). Vsync moved to 67 FPS...What do you mean when you say it resets? Vsync dropping to 67 FPS would indicate a frame rate problem, not a refresh rate problem. You can also use this to check: http://www.testufo.com/#test=frameskipping (11-02-2013 09:03 PM)neptune Wrote: 2nd... do I need to use HDMI in order to run 1080p at 60hz+ properly? Anything can be done to improve my results?HDMI and single-link DVI are basically the same on the video card, but the monitor might treat them differently. You also have to patch the driver if you want to go past the 165 MHz pixel clock limit. |
|||
|
|
« Next Oldest | Next Newest »
|