Custom Resolution Utility (CRU)

[Mussels]

(01-29-2020 05:52 PM)ToastyX Wrote:  

(01-29-2020 12:10 PM)Svyatoslav Wrote:  For some reasons it does the same result at 59Hz, at 60Hz, even at 64Hz and 70Hz. I agree that 29Hz is out of 30-61Hz range, thats why i set up 29-61Hz. Some people say if you setup just 60 then freesync doesnt use value of 60, the higer value it use in such setup is 59, that's why you should put 61. Don't kbow if it's true or not, as i mentioned above, my monitor goes with both refresh rates at the same result.

By the way, i got rid of artifacts in games by setting up limits to 19-61 Hz. Don't know how it works and how it helped.. But Pendulum if i simulate 40-60 works smooth, if i simulate 50fps - works smooth as well, but if i simulate 60fps - sometomes i see tearing. So freesync doesn't work 100%.

Who knowes how to set it up in details?

If you put 29-61 Hz but the detailed resolution is 59.996 Hz, then the range is 29-59.996 Hz. You need to change the detailed resolution to match.

This is similar to what i ran into when nvidias CP had refresh rates that wouldnt delete, so while i had a 60-65Hz range setup NVCP was forcing 63Hz in some titles - and I got that weird flickering bar at 64-65FPS, while 65Hz worked fine on the desktop

You gotta make sure you have the ranges correct to match the new details, or it wont work

(Fast vsync was related somehow, but not the primary cause of the problem - it was adding +1 to the refresh rate and definitely not meant to behave that way, 60Hz became 61Hz etc)