Custom Resolution Utility (CRU)

[Nyaako]

(05-04-2024 12:18 AM)ToastyX Wrote:  

(05-03-2024 08:54 PM)Nyaako Wrote:  I guess it was confusing to read. But yes, after setting the custom VRR range (85-240) I ran restart.exe and LFC worked as intended. However, it was after I restarted or turn off/on my PC (not restart.exe) that the custom VRR range bugged out and for some reason LFC only activated when it's 57 fps or below. I open up CRU and see that the 85-240 is saved and such. That's when I have to use reset-all.exe to reset and re-configure the custom VRR range to 85-240 and using restart.exe to make it work again. Of course, it still breaks again when I restart or turn off/on my PC.

I'm asking what's the point of running reset-all.exe and reconfiguring the VRR range? All that does is put what you already had. Why not just run restart.exe after restarting the PC? If doing that works around the problem, then it's a graphics driver bug.

Oh, I tried using restart.exe after my PC restarted and still doesn't work. So I guess it's a graphics driver bug for HDMI 2.1 on the LG 27GR95QE-B.