Custom Resolution Utility (CRU)
|
12-05-2014, 02:33 PM
(Last edited: 12-05-2014, 02:41 PM by Danja)
Post: #1134
|
|||
|
|||
RE: Custom Resolution Utility (CRU)
(12-05-2014 02:18 PM)ToastyX Wrote:(12-04-2014 03:59 PM)Danja Wrote: Hey chaps, I've had a good read about and don't seem to be able to find out what's going on. I've got an AOC G2460FQ - which is advertised as a 144hz monitor. My problem? From what I'm reading, scan lines or PWM sensitivity.This doesn't sound like a PWM problem. Most monitors are edge-lit, so PWM wouldn't produce lines or bars. PWM is also tied to the refresh rate on most monitors, so it should be less noticeable at higher refresh rates. I don't have the CCC installed, I just have the drivers and control application settings from radeonpro (will that have an option in it?). I'm also running win 10 TP, but this same problem happens in my windows 7 install too. This is the third monitor I've had from amazon as I had suspected it might've failed, and they've all had this issue (I actually have two, as amazon screwed up and sent me too many and only wanted one returning). The dithering sounds possible, I'll track down the reg values and report back, thanks for reply EDIt: Also, while I remember, it doesn't matter if I pan up and down on the screen, or keep the mouse still and move my head up and down infront of the monitor, I can still see these lines.. does that change anything? |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: jeffeh12133, 72 Guest(s)