Custom Resolution Utility (CRU)

[DeadlyDNA]

ToastyX Hope all is well. I have a question about CRU/Pixel Clock Patch.

I am using AMD omega drivers 14.12 drivers. I have 3 Seiki 39inch monitor/tv in eyefinity.
They are currently hooked up as follows 1straight HDMI, 2nd HDMI to DVID, 3rd HDMI to DVID to a 290x video card.

I have found many issues attempting to get this to work up until now. It may have something to do with eyefinity and custom resolutions/refresh.

Problem im having:

Monitors by default will not work in eyefinity unless i modify with CRU after pixel patch is applied.
And i have to do the following to make it work. I have to be at 61hz refresh rate if i do any other refresh rate even lower than 60 i get screen blanking intermittently. 61hz shows up as 60hz on my monitors OSD. Also, i have to uncheck "include extension block" for eyefinity to work properly.

I noticed with this unchecked, my resolutions offered in CCC show no HDTV but PC standard resolutions.
If i try to setup eyefinity say 100hz with include extension block checked, my 2 displays connected to the DVID ports display and odd resolution but proper refresh rate.

I.E. = 1 monitor@1080x1920-120hz displays fine(HDMI only) the other 2 display 960x1920@120hz.


sorry for the wall of txt, i am trying to figure out if this is a limitation with AMD drivers, or im not using CRU correctly