Custom Resolution Utility (CRU)

[wazer]

Hello i came here to ask where I'm doing wrong.

I recently Purchased the BenQ XL2720Z monitor.

I'm following this guide

http://www.blurbusters.com/benq/strobe-utility/

I put on blur reduction from benq menu, i use this utility CRU and setup resolution to this setttings

Create a new Custom Resolution of 1920×1080 at 120Hz (or refresh rate below 120Hz)
Change Timing to “Manual”
Change Vertical Total to “1350”

I also set IMPORTANT: If using ToastyX, set Horizontal “Total” to 2080. else screen looks like it got too much overclock after reboot



Reboot and when i come in its totally dark, i cannot see a thing, i need to either use my extreme flash light aiming from top and down to see just a tiny pixels so i can enter the benq menu and turn off blur reduction or just guess the benq menu and turn it off oO, as soon as i turn it on again, same results, instant dimmed down to like 1% vision.

What am i missing here? Thanks


If it helps anything here's my service menu settings and firmware?