Custom Resolution Utility (CRU)

[ToastyX]

(12-29-2014 10:16 AM)wazer Wrote:  Hello i came here to ask where I'm doing wrong.

I recently Purchased the BenQ XL2720Z monitor.

I'm following this guide

http://www.blurbusters.com/benq/strobe-utility/

I put on blur reduction from benq menu, i use this utility CRU and setup resolution to this setttings

Create a new Custom Resolution of 1920×1080 at 120Hz (or refresh rate below 120Hz)
Change Timing to “Manual”
Change Vertical Total to “1350”

I also set IMPORTANT: If using ToastyX, set Horizontal “Total” to 2080. else screen looks like it got too much overclock after reboot

[img]

Reboot and when i come in its totally dark, i cannot see a thing, i need to either use my extreme flash light aiming from top and down to see just a tiny pixels so i can enter the benq menu and turn off blur reduction or just guess the benq menu and turn it off oO, as soon as i turn it on again, same results, instant dimmed down to like 1% vision.

What am i missing here? Thanks

First, did you use the pixel clock patch? The pixel clock can't exceed 330 MHz without the patch.

Second, you should set the horizontal front porch to 48 and horizontal sync width to 32 as shown in the screen shot.

If that doesn't help, there might be a problem with the monitor.