|
Custom Resolution Utility (CRU)
|
|
12-23-2015, 07:24 AM
Post: #1880
|
|||
|
|||
RE: Custom Resolution Utility (CRU)
(12-23-2015 02:00 AM)ToastyX Wrote: That's normally the case with 1920x1080 monitors. Only 120/144 Hz monitors have dual-link DVI.Ouch, I should have asked here before rushing to buy a new cable. (12-23-2015 02:00 AM)ToastyX Wrote: This is under 165 MHz for 75 Hz, but I don't know if your monitor will accept it:It seems that whatever I set, if the total for Horizontal is lower than 1980, the new refresh rate does not appear in CCC after resetting the driver. (12-23-2015 02:00 AM)ToastyX Wrote: You might have better luck with HDMI. 7000-series and newer cards don't need the patch if HDMI support is defined in the extension block, and the monitor might accept higher pixel clocks with HDMI.Yes, you are completely right. I switched to HDMI and managed to get 75 Hz with LCD-standard profile without any issues. In fact, I can even get 80 Hz with the reduced profile using HDMI but I prefer to stick to 75 Hz and have my GPU running at correct idle clocks and not push my monitor too far. It seems that my monitor is more than capable of processing a pixel clock of up to at least 175 MHz but it doesn't support dual-link DVI signal. Now I have two DVI cables on my hand that I have no use for!  Anyway, thank you for your help and this great piece of software. |
|||
|
|
« Next Oldest | Next Newest »
|