Custom Resolution Utility (CRU)

[tako]

Hi,

I have two devices connected to an HDMI splitter. One of them is a TV with HDMI, the other is a monitor that connects using an HDMI to DVI cable. Both devices support 1080p, 60 hertz.

When the monitor is the primary device on the splitter, there's no audio on the TV because the TV goes into DVI Mode. If the TV is the primary, the monitor is not able to get any picture, I guess because of unsupported HDMI mode(s).

I've fiddled around with CRU and haven't been able to get it to work. I've only been able to switch the monitor into being seen as an HDMI device, but that stops the monitor from working - the TV comes up fine.

Any ideas? I can provide more detailed information about the monitor and TV models.