Post Reply
Strobelight - LightBoost Utility for AMD/ATI and NVIDIA
11-19-2013, 07:00 AM
Post: #278
RE: Strobelight - LightBoost Utility for AMD/ATI and NVIDIA
(11-18-2013 05:40 PM)BxBender Wrote:  Do i have to activate EDID in the AMD CCC?
There shouldn't be an EDID option if you're using DVI, unless you mean for the color temperature, which doesn't affect the refresh rates.

(11-18-2013 05:40 PM)BxBender Wrote:  What is with the alternative DVI-Mode? It is active in my CCC.
That's an old DVI compatibility option. It should be enabled.

(11-18-2013 05:40 PM)BxBender Wrote:  Your CRU tool showed me 3 resolutions: 120.5, 120 and 100.
I tried the reset-all tool and died a new install of the strobelight-tool and activated this time all resolutions but not the 144hz.
Now CRU shows me 120,110,100.
AMD CCC has 120,100,75,60...
Is the monitor listed as active in the setup program or CRU?

I need to know what happens if you disable the extension block in CRU, or even easier, try using the old setup program from beta 2: https://www.monitortests.com/strobelight-beta2.zip

If that doesn't work, then I don't have a solution because something is unusual about your setup. This is not an issue with the program itself. The program can't switch modes if the refresh rates aren't available.
Find all posts by this user
Quote this message in a reply
 Post Reply


Messages In This Thread
RE: Strobelight - LightBoost Utility for AMD/ATI and NVIDIA - ToastyX - 11-19-2013 07:00 AM
3D Vision WITHOUT LightBoost??? - weasel - 02-19-2014, 08:07 AM
RE: GeForce 344.11 - jayache80 - 10-06-2014, 02:25 AM
uninstalling failed? - l8nite - 11-04-2014, 06:21 PM
ASUS MG248Q - TeddyTries - 12-24-2019, 04:27 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)