The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.3.11-1~deb10u1 (Linux)
File Line Function
/showthread.php 802 errorHandler->error

 Post Reply
NEC MultiSync FE2111SB 1600x1200 85HZ?
01-13-2016, 04:57 AM
Post: #1
NEC MultiSync FE2111SB 1600x1200 85HZ?
As stated I have a NEC MultiSync FE2111SB that is connected to my R9 390 via VGA to HDMI.

I'm having issues trying to get it to 1600x1200 85Hz which it natively supports in the manual.

However, I am unable to get it to that while using CRU.

I patched my drivers using the tool for ATI cards.

When I set the CRU for that, while increasing the refresh rate it doesn't show up and when it does the image looks like I rolled the screen back on both sides.

I was able to use 1280x1024 at 90HZ however, I am wishing to use the native resolution.

I've tried HDMI to VGA and DP 1.1 to VGA.

I've taken out the 12th pin on my VGA cable, and I'm also getting a DP 1.2 and new VGA cable tomorrow to test out.

Shouldn't I be able to do 1600x1200 at 85HZ anyways? It should be under the spec of HDMI pixel clock.

Anyone have any ideas..

Find all posts by this user
Quote this message in a reply
 Post Reply

Messages In This Thread
NEC MultiSync FE2111SB 1600x1200 85HZ? - Aeather - 01-13-2016 04:57 AM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)