Post Reply
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
NEC MultiSync FE2111SB 1600x1200 85HZ?
01-14-2016, 07:58 PM
Post: #2
RE: NEC MultiSync FE2111SB 1600x1200 85HZ?
You didn't say you were using converters in your original post. Now you're talking about using two different types of converters. Converters have their own limitations. I don't know what the limitations are for your particular converters, but most VGA converters are only made to handle around 165-200 MHz pixel clock. That's not enough to get 1600x1200 @ 85 Hz with a CRT monitor.

(01-13-2016 04:57 AM)Aeather Wrote:  When I set the CRU for that, while increasing the refresh rate it doesn't show up and when it does the image looks like I rolled the screen back on both sides.
This statement contradicts itself. You say it doesn't show up, but then you say when it does show up, the image doesn't display properly. When does it show up and when does it not?

(01-13-2016 04:57 AM)Aeather Wrote:  I've tried HDMI to VGA and DP 1.1 to VGA.
Did you try the HDMI extension block with the HDMI-VGA converter? That should make the resolution available, but the converter might not be able to handle higher pixel clocks properly. I don't have a way to get around limits with DisplayPort converters.

(01-13-2016 04:57 AM)Aeather Wrote:  I've taken out the 12th pin on my VGA cable
Doing that prevents the monitor from being detected properly. You shouldn't need to do that if you're using CRU.
Find all posts by this user
Quote this message in a reply
 Post Reply


Messages In This Thread
RE: NEC MultiSync FE2111SB 1600x1200 85HZ? - ToastyX - 01-14-2016 07:58 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)