Custom Resolution Utility (CRU)

[ToastyX]

(01-18-2014 10:36 PM)Ninehundred Wrote:  I have a problem, i installed CRU and the Clock Patcher but it still don't work. When i setup my custom resolution to 2560*1600 @60hz, i reboot its fine i can select the new resolution, but when i do all my screen went Black.

(09-07-2012 09:06 PM)ToastyX Wrote:  

• This program adds monitor resolutions, not scaled resolutions. Lower resolutions will be scaled up if GPU scaling is enabled, but higher resolutions won't be scaled down by the GPU. Higher resolutions will only work if the monitor can handle them.
  

(01-18-2014 11:20 PM)Ninehundred Wrote:  Edit: Ive finnaly made it with a DVI cable so in other words the Samsung T240 ins't compatible with HDMI doing this.

But now i have to figured out why its all blurry.

Your monitor doesn't support dual-link DVI. You're trying to send a dual-link DVI signal to a single-link DVI monitor. That's not going to work properly.

You need a special version of the patcher to make the DVI port act like a single-link DVI port: https://www.monitortests.com/atikmdag-pa...-1.2.3.zip

The only question is whether your video card, cable, and monitor can handle 2560x1600 @ 60 Hz over a single link. The monitor is not intended to run at that resolution.