Custom Resolution Utility (CRU)

[falkentyne]

(11-21-2015 09:37 AM)Spec-Chum Wrote:  I used MonInfo yes, not sure why it didn't work properly.

1.2.4 works in that FreeSync is available now! However, 85hz is now saying out of range lol

---

Ah, quick update, keeping the range at 30-75hz makes 85hz work again and it's still saying freesync is available, but only up to 75hz I assume.

It doesn't seem to like the upper range being changed. Gives me an out of range error on 85hz.

---

Just tested, FreeSync works as normal when you select 75hz refresh rate but as soon as you select 85hz it turns off, even though it shows as enabled in CCC.

I was kinda hoping it'd work up to 75hz but alas, no, monitor shows mode as "normal" instead of "FreeSync".

---

OK, keeping the range 30-85hz and selecting a 75hz refresh rate makes FreeSync work as expected, obviously only up to 75 hz.

Looks like it doesn't like 85hz with FreeSync enabled, gives out of range error.

I don't know if this will help anyone, but in the Eizo Foris FS2735 manual, there are two refresh rates for freesync, depending on if you choose high or low range. And if you choose one range, certain refresh rates are "not available"

http://www.eizoglobal.com/products/foris...html#tab03

Look in the manual.